Steering column or shaft failure on the 2011 Toyota Tundra
When steering column or shaft failure gets reported
Owners of the 2011 Toyota Tundra report steering column or shaft failure at a median of 45,000 miles. A quarter of the reports come in before 25,000 miles and a quarter after 55,000 miles, from 8 reports that carried an odometer reading.
A part like this is normally expected to survive 85,000 miles. It is the 8th most-reported problem on this model year.
The mileage distribution
The reported range runs from 25,000 miles at the tenth percentile to 85,000 miles at the ninetieth, a spread of 61,000 miles across the middle 80% of reports.
When the reports scatter this far, the mileage is telling you about how these cars were driven more than about the part itself.
38% of the dated reports were filed under 36,000 miles.
The whole distribution
| 10th | 25th | Median | 75th | 90th |
|---|---|---|---|---|
| 23,000 miles | 23,000 miles | 45,559 miles | 55,500 miles | 84,000 miles |
Read the 10th percentile as “one report in ten arrived this early”. Exact figures are shown in this table because it is the table of record; everywhere else on the site they are rounded to the precision the sample can carry.
What a percentile can and cannot tell you here
These five numbers describe the readings owners gave, in order. The median is the middle one: half the reports arrived below it. The 10th and 90th are the edges of the bulk of the distribution, and the distance between them is the part worth reading. A tight spread — say 70,000 to 95,000 miles — points at something that wears out on a schedule, and the schedule is knowable. A wide one, 20,000 to 190,000, points at a fault that hits some cars and never troubles others, which means the mileage on the listing in front of you tells you very little about your odds.
What these figures are not is a survival curve. Every reading here comes from a car whose owner filed a complaint, so the sample contains only failures: it cannot say what share of the fleet made it past 150,000 miles untouched, because those owners had nothing to report. Nor is the mileage the moment of failure — it is the odometer reading as recalled at the time of filing, which may be weeks later and is sometimes rounded to the nearest ten thousand by the person typing it.
Percentiles are shown at all only once 8 readings exist for the vehicle and mode. Below that the middle of a handful of numbers is noise wearing a decimal point, so the figures are withheld rather than dressed up.
What happens, and what it costs
Putting it right typically runs $600–$2,500 at an independent US shop. That range is an editorial estimate held in this site's failure-mode catalogue, not a figure from NHTSA, and it is a repair cost rather than a diagnosis cost.
This mode is classified as critical, which means a failure can leave the car unable to stop, steer, or stay out of the way of traffic. It is weighted accordingly in the risk score.
The same failure on other years
The same failure is reported on 7 model years of this car. It shows up earliest on the 2000, at a median of 45,000 miles, and latest on the 2025 at 135,000 miles.
By volume the 2002 carries the most reports, with 12; the 2011 has 8. A mode that appears across most years of a model is usually a design choice rather than a bad batch.
If one year stands out to the left, that is the year to avoid; if the whole line sits at a similar mileage, this is wear rather than a defect in one production run.
Tick median reported mileage Solid middle half of reports Faint 10th to 90th percentile Colour how bad the failure is when it happens
What owners wrote
Verbatim from NHTSA complaint narratives, trimmed for length. The mileage is the one the owner gave.
I have a 2011 tundra sr5 with a loud clicking noise that has been coming from the steering column near the shift lever. While in park, the brake pedal must be pressed in order to shift the truck into gear. When I press the brake pedal, a loud click can be heard from the column shifter. This is the column shift lockout solenoid and is normal. However, recently I can hear the solenoid clicking anytime I depress the brake pedal while I'm in gear. Sometimes it is a click, two clicks and sometimes it is series of rapid clicks. I have taken the truck to the dealer twice. The first time I was told the clicking was normal while in park and that they could not duplicate it while in gear. The second time I took it to the dealer, they "blew out the excess grease" from the shift lock. Their best explanation is that the column shift lock solenoid comes from the factory as a sealed unit and is packed with grease. The 'excess' grease can keep the locking arm from fully retracking or engaging and the solenoid will chatter because it is trying to put it into position. *tr
I have a 2011 tundra sr5 with a loud clicking noise that has been coming from the steering column near the shift lever. While in park, the brake pedal must be pressed in order to shift the truck into gear. When I press the brake pedal, a loud click can be heard from the column shifter. This is the column shift lockout solenoid and is normal. However, recently I can hear the solenoid clicking anytime I depress the brake pedal while I'm in gear. Sometimes it is a click, two clicks and sometimes it is series of rapid clicks. I have taken the truck to the dealer twice. The first time I was told the clicking was normal while in park and that they could not duplicate it while in gear. The second time I took it to the dealer, they "blew out the excess grease" from the shift lock. Their best explanation is that the column shift lock solenoid comes from the factory as a sealed unit and is packed with grease. The 'excess' grease can keep the locking arm from fully retracking or engaging and the solenoid will chatter because it is trying to put it into position. *tr
I have a 2011 tundra sr5 with a loud clicking noise that has been coming from the steering column near the shift lever. While in park, the brake pedal must be pressed in order to shift the truck into gear. When I press the brake pedal, a loud click can be heard from the column shifter. This is the column shift lockout solenoid and is normal. However, recently I can hear the solenoid clicking anytime I depress the brake pedal while I'm in gear. Sometimes it is a click, two clicks and sometimes it is series of rapid clicks. I have taken the truck to the dealer twice. The first time I was told the clicking was normal while in park and that they could not duplicate it while in gear. The second time I took it to the dealer, they "blew out the excess grease" from the shift lock. Their best explanation is that the column shift lock solenoid comes from the factory as a sealed unit and is packed with grease. The 'excess' grease can keep the locking arm from fully retracking or engaging and the solenoid will chatter because it is trying to put it into position. *tr
Also reported on the 2011 Toyota Tundra
Other engine problem
Other electrical problem
Other fuel system problem
Wiring harness or short circuit
Steering rack, gear or tie rod failure
Other powertrain problem
How far this goes
Complaints are voluntary, so 8 is a floor and not a count of affected cars. Mileages are typed in by owners and cluster on round numbers. And the mode itself is assigned by software reading the complaint text, which is reliable in bulk and fallible one report at a time.
Questions this page answers
At what mileage does steering column or shaft failure happen on the 2011 Toyota Tundra?
Across 8 owner reports that included an odometer reading, half were filed by 45,000 miles. A quarter were filed before 25,000 miles and a quarter after 55,000 miles. These are the mileages owners reported when they complained, not a prediction for any individual car.
How common is steering column or shaft failure on the 2011 Toyota Tundra?
8 reports have been filed with NHTSA, about 0.2 per 1,000 vehicles. Complaints are voluntary, so this is a floor rather than a count of affected cars.
What this is and is not. These are the mileages at which owners chose to complain to a federal agency, which is not the same as the mileage at which the part fails on every car. It skews toward failures that happened outside warranty, cost real money, or frightened someone. It is still the only public dataset that carries failure mileage at all, and the shape of a few hundred readings is informative even when a single one is not. Methodology · JSON · this failure on other cars
Source Owner complaints and recall records published by the US National Highway Traffic Safety Administration, model years 1996–2027 Figures rebuilt Published by AtWhatMileage How every figure is computed